We will present the performance, safe operation methods, and technical parameters of পাইম (পি) প্রাফ/0.▁6▁kkv istectertransformer /c▁compopaction

পঞ্চা Introduction
পাইম (পি) 3▁3▁3▁kkvhigh-হুইজেটেজ/লো-নিউটেজ-আইলেডডডবিজেশন পর্যবেক্ষণবিকরণের নীচেনিয়ারকর্মেশন, ইওয়েস্টেটলেটেজফউইন্ড্ডাইউন্ড-ডাইনিস 0.▁6kv, জোওস্টেড্টো ফ্র্যাকভবি/3▁ষুব্ধ এবং 35/1▁1▁/ 1▁0▁নকভোস্টার্চশন দ্বারা ইয়েককভ্যাবিবললাইন পরাটার form▁ইন্টারিং ইন্টারফুমিটার প্রে-inledলেডডাডাবা এবং অ্যান্ড্রিকভিক্যালি স্টিমিইনসবক্স। Its formanceisfakelorlyinlinewthgb/T17 467 "অভিগ/লোনজেটেজেপ্রে-in▁stal▁stalলেডবস্টেশন", নিউইটাইপিওফ্র-এডডব্লিউপশন ৪০-এইচপেসিফিউজেশন অফ উইন্ডপোভার খিলামেন্টস, প্রতিদ্বন্দ্বী van আচরণstrucstrenstrength, ড্রানস্ট্যান্টি-কোর্সিওশন, অ্যান্ডিজেক্টলি অ্যান্ডেডিজেক্টেবল্যান্ডস, গ্রাইল্যান্ডস, ক্যারিয়ারল্যান্ডস্ট্রেট্রেটিং এমডিংয়েটমেন্টস ইডুইটসমুদ্রোক, এবং performformanceance্যান্সেক্লি-ফানিউট্রেটস
1. Model and meaning
YB M(P) - 35 (F) / 0.69-□
└──পার্স্কের Capacity (KVA)
└──Low Side Voltage (KV)
└── Dedicated to wind farms
└──High Voltage Side Voltage (KV)
└──M: Muzi structure, P: Pinzig structure
└──High/low voltage pre-installed substation
2. Normal use environmental conditions
2.1 Normal conditions of use
2.1.1 Operating ambient temperature: the ambient air temperature does not exceed 45 °C, and the average measured within 24 hours does not exceed 35 °C, and the minimum ambient air temperature is -30 °C;
2.1.2 Ambient humidity: the daily average relative humidity does not exceed 95%; the daily average of water vapor pressure does not exceed 2.2kPa, and the daily average of relative humidity does not exceed 90%; The average monthly water vapor pressure does not exceed 1.8 kPa
2.1.3 Altitude: ≤ 1000 meters
2.1.4 Seismic resistance: Seismic horizontal acceleration: less than 0.4m/s²
Vertical acceleration of the earthquake: less than 0.2m/s°
Safety factor: 1.67
2.1.5 There is no violent vibration at the installation site, and the inclination is not greater than 3°;
2.1.6 The wind speed is not greater than 35m/s
2.2 Special conditions of use
If the normal conditions of use cannot meet the requirements, it can be negotiated with the manufacturer.
3. Main technical parameters
3.1 Rated parameters of box variable
3.1.1 Voltage
Rated voltage on the high voltage side: 35kV
Rated voltage on the low voltage side: 0.69kV
3.1.2 Rated frequency: 50Hz
3.1.3 Rated insulation level
The rated insulation level of the ইস্মার meets the provisions of DL404-91 "Technical Conditions for Ordering Indoor AC High Voltage Switchgear".
High-voltage side: between the ground and the phase isolation break
Power frequency withstand voltage: 95kV 110kV
Peak Shock Voltage: 185kV 215kV
Low pressure side:
Power frequency withstand voltage: 2500V
3.1.4 Number of phases: three phases
3.1.5 Cabinet protection level: IP44D
3.2 Main technical parameters of transformers
3.2.1 Technical standards
The transformer complies with GB1094.1~1094.5 "Power পার্স্কের" and GB6451.1 "Technical Parameters and Requirements for Three-phase Oil-immersed Power পার্স্কের"
3.2.2 Technical parameters
| project | unit | parameter |
|---|---|---|
| Voltage Rating - Primary | KV | 35 |
| Voltage Rating - Secondary Side | KV | 0.69 |
| Maximum operating voltage | KV | 40.5 |
| Rated frequency | HZ | 50 |
| Rated capacity | KVA | 1600、2200、3150 |
| 1-minute power frequency withstand voltage | KV | 95 (without transformer), 85 (transformer) |
| BIL impact pressure | KV | 185 |
| Cooling method | - | Oil-immersed self-cooling |
| No load pressure regulation | KV | 35±2×2.5% |
| Ambient temperature | ℃ | - 45 - +40 |
| The transformer allows the oil top layer to rise in temperature | K | ≤55 |
| The temperature rise of the transformer low-voltage winding | K | ≤65 |
| The temperature rise of the transformer's high-voltage winding | K | ≤65 |
| Noise level | dB | ≤55 |
| Protection level | - | IP33D |
4. পঞ্চা structure and characteristics
4.1.1windfrontsarsarewerwerক্যালি il▁il▁টিইন্ডাল্ডাল্লাটস, রিলাল্লাস, গ্র্যাগল্যান্ডস, এবং উত্সাহ-অ্যান্টি-ক্রোরসিশন pro▁ces▁...সেসিস্টিকোর্ডিংয়ের জন্য কোর্ডিংয়ের কোর্ডিংয়ের জন্য ইস্যুরকমেন্টে-ভিজালিউ-প্রে-আই
4.▁1.2theoallল্টআউটফথবক্সেরিস" পুরস্কার "ধরন, এবং তাদের বিরোধী van thheanectionbetweenthe maincomponents is conveneinty, এবং ক্যাম্প্রোইস-এফপেরোয়ারিয়াটেক্লিসিড; ইউইং স্পেস এবং mainintenten▁চেনান্সস্পেস অফ ডাইলেট্যান্ড নোটিলেটলেট-এল্লাইসেল্লা, উইচি বক্স strucচার: সমস্ত metmetalturaltsts রকম সিডালস্টেড, আমন-dipgalvanized, এবং পিপ-কচচ্যান-সুইরিজেড, অ্যালডোর এন্ডওয়ালললস, স্পেন্ডারিইসনো লেটায়ার, এবং আন্দলিস্ফ ডিল্লিস্ফলিউইট ওয়াইটড্যান্ডেলিকট্রিক অ্যালাইট-সিপুলেশনাল, নীচেমাল স্যারিল্লাইমল মিনিসপিলেশন form▁...সুইউরিতে প্রতিক্রিয়া হিসাবে নির্দিষ্ট এবং কুইক্যালিমি
বি.3.th.th.s.erinsinininininininininopopopopopopopopopopopopopopopopsssss▁রকম্ফোর-অ্যানুইউবল-ক্যুইল্ডিং-লো-লো-পিওর, এবং ইহারপেস-অফ-এইচওভারসআর 11 টাইপপোভার আরোহী-বোর্ড এবং লোড ...অ্যালোয়ারিয়ান রিপোর্টিংয়ের ইংরেজিমেন্টস national উত্থাপন্থী আর্টিকসফ-এইচ-এনডিসিএনড্লো, উইচক্যান্ডোলোটফপোভার sum▁ption এবং পিটিভিং টিভিস্টস, এবং ...সাইলবিহীন ইনকোরফোর্সোসি-অভিসিটিটিল-রওইটেডগ্রিফিন-ori▁এসেটেডসিলকন আইটেল
.....Lililiণিঞ্জেন্ট ir স্যা-ফোনাসের ক্রোলাইংন্দন্দ্রোথর-এফরোকিউন্টস। আর্ট্যাসেমটাইম, এস্কমল ininintenten▁রঙের জন্য নির্ধারিত-নির্দেশকদের জন্য ...বিভিডিওয়ারতে mainintenten▁ten▁ন্যান্সসাইট। টেইস্ট্রেটিভিক্যাল টিমমসফ-লো-কিউন্টেজেজেটেজ-জেট্র্যামেয়ার-আই
5. Maintenance, inspection and precautions
5.1 Maintenance
5.1.1 Regular inspection matters
a. Check whether each signal and indicator is normal;
5.1.2 Annual inspection and maintenance matters
a. Check whether the connection points of the primary and secondary circuits are loose or overheated;
b. Use a megaohm meter to check the insulation between phases and the ground to observe whether there is damage or aging;
c. If the transformer is oil-immersed, the oil sample analysis and inspection should be carried out at least once a year according to the regulations.
dRemove dust and foreign objects;
eMake various inspection records.
5.1.3 Maintenance and precautions
When an abnormal phenomenon or a certain part is found to be abnormal, it must be stopped for maintenance or replacement, and the upper power supply must be disconnected and a reliable grounding wire must be hung up during the inspection.
6. Ordering instructions
When ordering, the user should specify that:
6.1 Model and quantity of pre-installed substations;
6.2 পার্স্কের model and capacity;
6.3 Provide electrical primary system and secondary schematic diagram
